Assemble Discharge Chute - Briggs & Stratton 1695360 Operator's Manual

Assembly
3. Secure lift rod assembly with safety clip (a, Figure 13).
Secure lift lever assembly with clevis pin (K) and safety
clip (L).
Figure 13

Assemble Discharge Chute

1. Remove the motor cover (a, Figure 14) and loosen the
screws (b) securing the electric spout rotator motor.
Remove the motor gear (c) and set aside.
c
Figure 14
2. Lubricate the base of the discharge chute and ring gear
with automotive lithium grease.
14
3. Remove a chute retainer (d, Figure 15) and plastite
screw (e), located on the reinforcement ring gear (f) of
discharge chute assembly (LL).
K
L
a
Figure 15
4. Install the discharge chute assembly (LL, Figure 16) to
the chute ring (f) using the chute retainer (d) previously
removed in Step 3 and plastite screw (e).
a
LL
e
b
Figure 16
LL
d
d
e
f
f