Mount Remote Deflector Control; Rear Lift Rod Alteration; Install Drift Cutters - Briggs & Stratton 1695360 Operator's Manual

Mount Remote Deflector Control

1. Using the template (a, Figure 35) included in the back
of this manual, drill two 9/32" holes in the left side of the
dashboard to mount the remote chute control.
a
Figure 35
2. Mount the mounting bracket assembly (RR, Figure 36)
to the dashboard. Secure with capscrews (a), large flat
washers (b) and nuts (c).
RR
Figure 36
3. Install the remote deflector control handle (a, Figure 37)
in the mounting bracket assembly and secure with a
clevis pin (b) and hair pin clip (c).
Figure 37
c
a
b
a
c

Rear Lift Rod Alteration

Units with Suspension
On units with suspension, adjustment handle (a, Figure 36)
on rear hitch assembly may interfer with suspension cross
shaft (b). If so, remove 1
Figure 38

Install Drift Cutters

1. On each side of snowthrower, insert bottom tab of drift
cutter (SS, Figure 39) into slot on snowthrower.
Secure in place with capscrew (S) and nut (T).
b
T
Figure 39
Assembly
/ from end of adjustment rod.
1
2"
a
SS
S
b
19