Attach Chute Motor Wiring Harness (Non-Electric Deck Lift Models) - Briggs & Stratton 1696423-00 Operator's Manual

Assembly
Attach Chute Motor Wiring Harness
(Non-Electric Deck Lift Models)
NOTE: Open hood on tractor for installing the wire harness.
1. Remove plug from tractor dashboard (a, Figure 18).
Figure 18
2. Plug female connector of the upper wiring harness (N,
Figure 19) into switch (O).
Figure 19
3. Route the upper wiring harness (N, Figure 20) and
switch (O) through opening in dashboard. Snap switch
into dashboard to secure.
O
Figure 20
14
a
N O
N
4. Locate the tractor power leads (Figure 21), red with
yellow stripe (b) and black (c), at the base of steering
column. Connect these leads, color to color, to the
upper wiring harness (N).
IMPORTANT: DO NOT use yellow and black power
tractor lead.
Figure 21
5. Route the upper wiring harness along the right side of
the tractor.
6. Connect the chute rotation wiring harness (d, Figure 22)
from the snowthrower to the square black plug from the
upper wiring harness (e). Position the wiring heat cover
underneath the muffler.
NOTE: Wire harness (d) may be in hardware bag or
connected to snowthrower.
d
Figure 22
N
b
c
e d