Assembly; Assemble Hitch; Assemble Push Bar Latch - Briggs & Stratton 1695360 Operator's Manual

Assembly

WARNING
Before beginning any service work turn off the PTO, set
the parking brake, turn off the ignition, and disconnect
the spark plug wire(s).
Refer to "Tractor" operating manual for mower removal.

Assemble Hitch

1. Attach the support clamp (AA, Figure 1) to the sub-
frame hitch (BB) with carriage bolts (A), washers (B),
lockwashers (C), and nuts (D). Support clamp should
be able to slide. Do not tighten the hardware at this
time. It will be tightened in Step 6 of "Install Sub-
Frame Hitch."
2. Insert hook assembly (CC) into support clamp.
Conquest, Prestige & CTX 9500
CC
BB AA
Broadmoor & CTX 9000
CC
BB
AA
Figure 1
10

Assemble Push Bar Latch

For 2012 Models & Previous Years
1. Attach push bar latch (DD, Figure 2) onto each side of
sub-frame hitch (BB). Secure with capscrews (E) and
nuts (G) on both sides.
NOTE: Refer to Figure 2 for four wheel drive and two
wheel drive push bar latch placement.
Figure 2
A
B
C
D
BB DD
4 Wheel Drive
2 Wheel Drive
G
E