Table of Contents
Advertisement
Assembly
Install Drive Belt
1. Route the drive belt (TT) as shown in Figure 40. The
back of the belt rides in the back-side idlers (2 & 4).
NOTE: The snowthrower hitch pin goes in between the
belt, NOT below or above it.
2. The following is a list of pulley names and type of pulley.
Refer to Figure 40 for proper routing of belt.
1 - Snowthrower Input Pulley (a)
2 - Backside Idler Pulley (b)
3 - Tractor PTO Pulley (a)
4 - Backside Idler Pulley (b)
5 - Idler V-Pulley (a)
a
V-Pulley (
)
Flat Pulley (
1
Figure 40
20
b
)
3
2
TT
3. With the snowthrower drive belt installed, the trunnion
(a, Figure 41) should be between the marks (b) on
spring tension bracket for correct belt tension. Turn
belt tension handle (c) to move trunnion until between
marks.
4. If trunnion cannot be placed between marks,
loosen capscrew (d) and reposition idler V-pulley
(5) as necessary. The pivot bracket (e) should be
perpendicular to snowthrower hitch.
4
5
2 .
Figure 41
Install Reflectors
1. Place reflectors (U, Figure 40) on rear of tractor below
operator's seat.
Figure 42
b
a
5
d
U
e
c
Hide quick links:
Advertisement
Table of Contents
