Assembly; Unpacking; Chute Assembly - Briggs & Stratton 1696423-00 Operator's Manual

Hardware / Parts Identification
Lower case letters identify pre-assembled and / or pre-
existing hardware / parts.
Upper case letters identify hardware / parts that are found in
the kit (pages 4-5).

Unpacking

1. Position box close to the tractor and carefully unpack
and organize snowthrower parts.
IMPORTANT: See (a, Figure 1) for correct orientation of
snow drive pulley hub.
2. If snow drive pulley hub orientation is incorrect, loosen
set screw, remove and flip pulley to correct orientation
and tighten set-screw.
CORRECT
INCORRECT
Figure 1

Chute Assembly

1. Remove gear cover (a, Figure 2) from the snowthrower
2. Remove chute rotator gear (c) from shaft.
Figure 2
3. Align chute (B, Figure 3) notch (d) on chute with
a
Figure 3
assembly (A) by removing hex screw (b) and tilting the
gear cover to disengage tab on opposite side of box.
a a
b
housing chute ring tab (e) and slide chute into place.

Assembly

c
A
B
d
e
9