JRC JUE-87 Instruction Manual page 105

A3.3.2 Change of Ribbon Cassette-cartridge
Mounting method
1) Verify that the power switch remains turned OFF.
2) Turn the cassette knob in arrow mark direction to give tension to the ribbon.
3) In case of paper stand has been mounted, loosen stand-holding screw, and slide the paper stand
backward.
4) Remove the printer cover.
Immediately after printing, the printing head is still very hot, don't touch it until it is cool down.
5) Move by hand the printing head to its home
position (left end).
6) Put the ribbon cassette so as the ribbon is
placed between the ribbon mask and printing
head. At that time, arrange so as the
ribbon-feeding shaft enters in a hole located
under the ribbon cassette knob.
7) Push lightly from top both ends of the
ribbon cassette.
8) Turn again the cassette knob to give tension
to the ribbon.
9) Verify that the ribbon is correctly placed in
front of the printing head.
DANGER
A3-5
A2-5