Roll Paper Loading - JRC JUE-87 Instruction Manual

A2.3.3 Roll Paper Loading
1) Verify that the pover switch remains turned OFF.
2) Open the printer cover.
3) Remove the roll paper cover. At this step, pull the friction lever towards the front.
4) Pass the roll bar through the roll paper, and install the roll paper onto the roll paper stand in the
right direction. When passing the roll bar through the roll paper, push the roll bar all the way in.
5) Pass the roll paper over the guide bar as shown in the figure. Adjust the side guides to the paper
width.
6) Insert the leading edge of the paper into the rear of the platen. Then turn the paper feed knob to
feed the paper out and adjust the direction.
7) After adjusting the paper direction, return the friction lever to the back to fix the paper.
Side guide
Platen
Guide bar