Front Panel Unit Removal - Epson FilmScan 200 Service Manual

FilmScan 200

3.2.3 Front Panel Unit Removal

Step 1: Remove the upper case (Refer to section 3.2.2.)
Step 2: Remove the two C.B (M3 x 6) screws and remove the front panel unit.
Step 3: Disconnect the FFC cable from the LED board connector (lock type).
Step 4: Disconnect connector from the micro switch board B on the front panel unit then take the front
panel unit away.

Be sure that the insertion direction of the FFC cable.

Apply the Screw-lock when installing the three screws.
3-6
To Micro Switch Board B
Figure 3-3. Front Panel Unit Removal
Blue
LED Board
Figure 3-4. FFC Disconnect
ASSEMBLING POINT
Front Panel Unit
(1)
(2)
FFC
Connector
Microswitch
Board B
(1)
(2)
Rev. A