Epson FilmScan 200 Service Manual page 39

FilmScan 200
2.1.3 Film Carrier or APS Holder Selection
The scanner is available to load either the film carrier for 35 mm film or the APS holder for APS negative
film cartridge.
2.1.3.1 Front Panel Unit Face Change
The front panel unit has two different faces by the positioning of the cover (Refer to Figures 2-10 and 2-
11.). It is switched either film carrier or optional APS holder is installed to the scanner, and the status is
monitored by two switches. Refer to Table 2-1.
Cover
Micro Switch B (close)
Figure 2-10. Front Panel Unit Status
Film Type Cover Status
Film Carrier Close
APS Holder Open
(Press and hold the button
while pushing the door down
until it clicks into place.)
2-6
Front Panel Unit
Film Carrier
(Film Carrier)
Table 2-1. Film Type and Switch Status
Cover
Figure 2-11. Front Panel Unit Status
Micro Switch B Status
Close
Open
Front Panel Unit
APS Holder
Micro Switch B
(open)
Button
(APS Holder)
Micro Switch A Status
Inactive
APS holder is installed:
Close
APS holder isn't installed:
Open
* Refer to Figure 2-12.
Rev. A