Set Udpserial - Digi ConnectPort LTS8 Command Reference Manual

Command descriptions

set udpserial

Purpose
Configures and displays current settings for the UDP serial feature. This feature allows data to be
sent between the serial port and one or more remote network destinations using the UDP protocol.
When this feature is enabled for a given serial port, data sent to the serial port will be sent out to the
configured destinations. Also any time data is sent to the UDP serial service (IP port 2101) and the
serial port is not being used by another service, the data will be sent to the serial port.
Required permissions
For products with two or more users, to use this command, permissions must be set to one of the
following:
For a user to display the UDP serial settings for the line on which they are logged in: "set
n
permissions s-udpserial=r-self"
For a user to display the UDP serial settings for any line:
n
"set permissions s-udpserial=read"
n
For a user to display and set the UDP serial settings for the line on which they are logged in:
n
"set permissions s-udpserial=rw-self"
For a user to display the UDP serial settings for any line, and set UDP serial settings for the line
n
on which the user is logged in:
"set permissions s-udpserial=w-self-r"
n
For a user to display and set the UDP serial settings on any line:
n
"set permissions s-udpserial=rw"
n
See "set permissions" for details on setting user permissions for commands.
Syntax
Set general UDP serial forwarding characteristics for a serial port
set udpserial port={range|xbee|internalmodem}
[state={on|off}]
[sendcount=bytes]
[sendtime={0| time }]
[endpattern= string ]
[strippattern={on|off}]
[sid={on|off}]
[sidstring= string }
Set UDP destinations for a given serial port
set udpserial port= range
range=1-64
[active={on|off}
ConnectPort® LTS Command Reference
set udpserial
146