Set Ppp - Digi ConnectPort LTS8 Command Reference Manual

Command descriptions

set ppp

Purpose
Configures Point-to-Point Protocol (PPP) connections, or displays current PPP settings.
Required permissions
Permissions must be set to one of the following:
For a user to display the PPP settings: "set permissions s-ppp=read"
n
For a user to display and set the PPP settings: "set permissions s-ppp=rw"
n
Syntax
Add a new ppp setting
set ppp add index=1-64
newname= new username
connection_type={incoming|outgoing}
Remove a PPP setting
set ppp remove index=1-64
Configure ppp settings
set ppp [index=1-64]
[connection_type={none|incoming|outgoing}]
[user= username ]
[password= password ]
[pppauth={none|chap|pap|both}]
[ipaddrmode={ippool|negotiated|static}]
[ipaddr= ip address ]
[phonenumber1= phone number ]
[phonenumber2= phone number ]
[localipaddr_ mode={none|unnumbered|static}]
[localipaddr= ip address ]|
[idletimeout=0-65535]
[proxy_arp={off|on}]
Display ppp current settings
set ppp
Options
add
Add a PPP setting.
remove
ConnectPort® LTS Command Reference
set ppp
92