3Com 7700 Configuration Manual page 36

28 C 2: P C
HAPTER ORT ONFIGURATION
Setting Link Type for Ethernet Port
■
Adding the Ethernet Port to a VLAN
■
Setting the Default VLAN ID for Ethernet Port
■
Entering Ethernet Port View
Before configuring the Ethernet port, enter Ethernet port view first.
Perform the following configuration in system view.
Table 1 Enter Ethernet Port View
Operation
Enter Ethernet port view
Note: In the Switch 7700, the subslot is always 0.
Enabling and Disabling Ethernet PortS
The following command can be used for disabling or enabling the port. After
configuring the related parameters and protocol of the port, you can use the
following command to enable the port.
Perform the following configuration in Ethernet port view.
Table 2 Enable/Disable an Ethernet Port
Operation
Disable an Ethernet port
Enable an Ethernet port
Note: The port is enabled by default
Setting Description Character String for Ethernet Port
You can use the following command to identify the Ethernet ports.
Perform the following configuration in Ethernet port view.
Table 3 Set Description Character String for Ethernet Port
Operation
Set description character string for
Ethernet port.
Delete the description character
string of Ethernet.
Note: The port description is a null character string by default.
Setting Duplex Attribute of the Ethernet Port
Set the port to full duplex to send and receive data packets at the same time. Set
the port to half-duplex to either send or receive only. If the port has been set to
auto-negotiation mode, the local and peer ports will automatically negotiate the
duplex mode.
Command
interface {Gigabit | Ethernet} slot/subslot/port
Command
shutdown
undo shutdown
Command
description text
undo description