Configure Snmp - 3Com 7700 Configuration Manual

The current SNMP Agent of Ethernet switch supports SNMP V1, V2C and V3. The
MIBs supported are listed in the following table.
Table 44 MIBs Supported by the Ethernet Switch
MIB
attribute
Public MIB
Private MIB

Configure SNMP

The main configuration of SNMP includes:
■
■
■
■
■
■
■
■
■
■
■
■
Setting the Community Name
Both SNMP V1 and SNMPV2C adopt the community name authentication scheme.
The SNMP message incompliant with the community name accepted by the device
will be discarded. SNMP Community is named with a character string, which is
called Community Name. The various communities can have read-only or
read-write access mode. The community with read-only authority can only query
the device information, whereas the community with read-write authority can also
configure the device.
MIB content
MIB II based on TCP/IP network
device
BRIDGE MIB
RIP MIB
RMON MIB
Ethernet MIB
OSPF MIB
IF MIB
DHCP MIB
QACL MIB
ADBM MIB
RSTP MIB
VLAN MIB
Device management
Interface management
Setting the Community Name
Setting the Method of Identifying and Contacting the Administrator
Enabling and Disabling the SNMP Agent to Send Trap
Setting the Destination Address of Trap
Setting the Lifetime of the Trap Message
Setting sysLocation
Setting the Engine ID of a Local or Remote Device
Setting and Deleting an SNMP Group
Setting the Source Address of the Trap
Adding and Deleting a User to or from an SNMP Group
Creating and Updating View Information or Deleting a View
Setting the Size of SNMP Packet Sent/Received by an Agent
SNMP
References
RFC1213
RFC1493
RFC2675
RFC1724
RFC2819
RFC2665
RFC1253
RFC1573
25