3Com 7700 Configuration Manual page 242

234 C 8: STP O
HAPTER PERATION
Configuring the Port
Connection with the
Point-to-Point Link
Table 34 Configure the Port Priority
Operation
Restore the default port priority.
For more about the commands, see the Switch 7700 Command Reference Guide.
After the change of port priority, MSTP will recalculate the port role and transit the
state. A smaller value represents a higher priority. If all the Ethernet ports of a
switch are configured with the same priority value, the priorities of the ports will
be differentiated by the index number. The change of Ethernet port priority will
lead to spanning tree recalculation. You can configure the port priority by actual
networking requirements.
By default, the priority of all the Ethernet ports is 128.
The point-to-point link directly connects two switches.
You can configure the port to connect or not connect with the point-to-point link
in the following ways.
Configuring in System View
Perform the following configuration in system view.
Configure the port connection with the point-to-point link
Table 35
Operation
Configure the port to connect with the
point-to-point link.
Configure the port not to connect with the
point-to-point link.
Configure MSTP to automatically detect if the
port is directly connected with the
point-to-point link.
Configure MSTP to automatically detect if the
port is directly connected with the
point-to-point link, as defaulted.
Configuring in Ethernet Port View
Perform the following configuration in Ethernet port view.
Configure the port connection with the point-to-point link
Table 36
Operation
Configure the port to connect with the
point-to-point link.
Configure the port not to connect with the
point-to-point link.
Configure MSTP to automatically detect if the
port is directly connected with the
point-to-point link.
Configure MSTP to automatically detect if the
port is directly connected with the
point-to-point link, as defaulted.
For more about the commands, see the Switch 7700 Command Reference Guide.
Command
undo stp instance instance-id port priority
Command
stp interface interface-list point-to-point
force-true
stp interface interface-list point-to-point
force-false
stp interface interface-list point-to-point
auto
undo stp interface interface-list
point-to-point
Command
stp point-to-point force-true
stp point-to-point force-false
stp point-to-point auto
undo stp point-to-point