Configuring A Switch To Track An Interface; Displaying And Debugging Vrrp - 3Com 7700 Configuration Manual

268 C 10: R
HAPTER ELIABILITY
Configuring a Switch to
Track an Interface
Displaying and
Debugging VRRP
Example: VRRP Single
Virtual Router
Perform the following configuration in VLAN interface view.
Table 7 Configure VRRP Timer
Operation
Configure VRRP timer
Clear VRRP timer
By default, adver-interval is configured to be 3.
VRRP interface track function expands the backup function. Backup is provided
not only to the interface where the virtual router resides, but also to other
malfunctioning switch interfaces. By implementing the following command you
can track interfaces. If the interface that is being tracked fails, the priority of the
switch, including the interface, decreases automatically by the value specified by
value-reduced. The reduced priority of the switch results in comparatively higher
priorities of other switches within the virtual router, one of which becomes the
master switch, to track this interface.
Perform the following configuration in VLAN interface view.
Table 8 Configure Switch to Track a Specified Interface
Operation
Configure to track a specified
interface
Stop tracking the specified
interface
By default, value-reduced is set at 10.
Note: When the switch is an IP address owner, its interfaces cannot be tracked.
After you configure a virtual router, execute the display command in all views to
display the running of the VRRP configuration, and to verify the effect of the VRRP
configuration.
Table 9 Display and Debug VRRP
Operation
Display VRRP state information.
Enable VRRP debugging.
Disable VRRP debugging.
You can enable VRRP debugging to display how it runs. You can set the argument
option to packet or state to debug the VRRP packet or VRRP state, respectively.
By default, the switch disables debugging.
Host A uses the VRRP virtual router which combines switch A and switch B as its
default gateway to visit host B on the Internet.
Command
vrrp vrid virtual-router-ID timer advertise adver-interval
undo vrrp vrid virtual-router-ID timer advertise
Command
vrrp vrid virtual-router-ID track vlan-interface
interface-num [ reduced value-reduced ]
undo vrrp vrid virtual-router-ID track [ vlan-interface
interface-num ]
Command
display vrrp [ interface vlan-interface interface-num ]
[ virtual-router-ID ]
debugging vrrp { state | packet }
undo debugging vrrp { state | packet }