should be noted that after OSPF is disabled, the OSPF-related interface parameters
also become invalid.
OSPF configuration includes the tasks that are described in the following sections:
Enable OSPF and Enter OSPF View
■
Enter OSPF Area View
■
Specify Interface
■
Configure Router ID
■
Configure the Network Type on the OSPF Interface
■
Configure the Cost for Sending Packets on an Interface
■
Set the Interface Priority for DR Election
■
Set the Peer
■
Set the Interval of Hello Packet Transmission
■
Set a Dead Timer for the Neighboring Routers
■
Configure an Interval Required for Sending LSU Packets
■
Set an Interval for LSA Retransmission Between Neighboring Routers
■
Set a Shortest Path First (SPF) Calculation Interval for OSPF
■
Configure the OSPF STUB Area
■
Configure NSSA of OSPF
■
Configure the Route Summarization of OSPF Area
■
Configure OSPF Virtual Link
■
Configure Route Summarization Imported into OSPF
■
Configure the OSPF Area to Support Packet Authentication
■
Configure OSPF Packet Authentication
■
Configure OSPF to Import the Routes of Other Protocols
■
Configure Parameters for OSPF to Import External Routes
■
Configure OSPF to Import the Default Route
■
Set OSPF Route Preference
■
Configure OSPF Route Filtering
■
Configure Filling the MTU Field When an Interface Transmits DD Packets
■
Disable the Interface to Send OSPF Packets
■
Reset the OSPF Process
■
Enable OSPF and Enter OSPF View
Perform the following configurations in system view.
Table 22 Enable OSPF Process
Operation
Enable the OSPF process
Disable the OSPF process
Command
ospf
undo ospf
OSPF
79