3Com 7700 Configuration Manual page 17

Figure 7 Setting up the Configuration Environment Through Telnet
Workstation
Server Workstation
4 Run Telnet on the PC by selecting Start > Run from the Windows desktop and
entering Telnet in the Open field, as shown in Figure 8. Click OK.
Figure 8 Run Telnet
5 On the Connect dialog box, enter the IP address of the VLAN connected to the PC
port and set the terminal type to VT100, as shown in Figure 9.
Figure 9 Connect Ethernet Switch by Telnet
The terminal displays User Access Verification and prompts you for the logon
password.
6 Enter the password,. The terminal displays the command line prompt (
If the message,
Too many users!
Telnet users are allowed to log on to the Switch 7700 Switch simultaneously.
7 Use the appropriate commands to configure the Ethernet switch or to monitor the
running state. Enter
?
refer to the chapters in this guide.
Ethernet port
PC (for configuring
the switch through Telnet)
appears, try to reconnect later. At most, 5
to get the immediate help. For details of specific commands,
Setting Terminal Parameters
<SW7700>
9
).