Priority Commands (Layer 3 And 4); Map Ip Dscp (Global Configuration); Table 3-5 Priority Commands (Layer 3 And 4) - Edge-Core ES4524M-PoE Management Manual

4
Command Line Interface

Priority Commands (Layer 3 and 4)

This section describes commands used to configure Layer 3 and Layer 4 traffic
priority on the switch
Command
map ip dscp
map ip dscp
show map ip dscp

map ip dscp (Global Configuration)

This command enables IP DSCP mapping (i.e., Differentiated Services Code Point
mapping). Use the no form to disable IP DSCP mapping.
Syntax
[no] map ip dscp
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The precedence for priority mapping is IP DSCP and default switchport
priority.
Example
The following example shows how to enable IP DSCP mapping globally.
Console(config)#map ip dscp
Console(config)#
4-240

Table 3-5 Priority Commands (Layer 3 and 4)

Function
Enables IP DSCP class of service mapping
Maps IP DSCP value to a class of service
Shows the IP DSCP map
Mode Page
GC 4-240
IC 4-241
PE 4-242