Figure 3-62 Port Broadcast Control - Edge-Core ES4524M-PoE Management Manual

Web – Click Port, Port Broadcast Control or Trunk Broadcast Control. Set the
threshold for each port, click Apply.
CLI – Specify any interface, and then enter the threshold. The following disables
broadcast storm control for port 1, and then sets broadcast suppression at 500
packets per second for port 2.
Console(config)#interface ethernet 1/1
Console(config-if)#no switchport packet-rate
Console(config-if)#exit
Console(config)#broadcast packet-rate 64000
Console(config)#exit
Console#show interfaces switchport ethernet 1/2
Information of Eth 1/2
Broadcast Threshold:
Multicast Threshold:
Unknown-unicast Threshold:
LACP Status:
Ingress Rate Limit:
Egress Rate Limit:
VLAN Membership Mode:
Ingress Rule:
Acceptable Frame Type:
Native VLAN:
Priority for Untagged Traffic: 0
GVRP Status:
Allowed VLAN:
Forbidden VLAN:
Private-VLAN Mode:
Private-VLAN host-association: NONE
Private-VLAN Mapping:
Console#

Figure 3-62 Port Broadcast Control

Enabled, 64000 Kbits/second
Disabled
Disabled
Disabled
Disabled, 1000000 Kbits per second
Disabled, 1000000 Kbits per second
Hybrid
Enabled
All frames
1
Disabled
1(u),4093(t),
NONE
NONE
Port Configuration
4-135
4-141
4-141
4-145
3-119