Lldp Mednotification - Edge-Core ES4524M-PoE Management Manual

Command Usage
• This option sends out SNMP trap notifications to designated target stations at
the interval specified by the lldp notification-interval command
(page 4-215). Trap notifications include information about state changes in
the LLDP MIB (IEEE 802.1AB), or vendor-specific LLDP-EXT-DOT1 and
LLDP-EXT-DOT3 MIBs.
• SNMP trap destinations are defined using the snmp-server host command
(page 4-64).
• Information about additional changes in LLDP neighbors that occur between
SNMP notifications is not transmitted. Only state changes that exist at the time
of a trap notification are included in the transmission. An SNMP agent should
therefore periodically check the value of lldpStatsRemTableLastChangeTime
to detect any lldpRemTablesChange notification-events missed due to
throttling or transmission loss.
Example
Console(config)#interface eth 1/1
Console(config-if)#lldp notification
Console(config-if)#

lldp mednotification

This command enables the transmission of SNMP trap notifications about
LLDP-MED changes. Use the no form to disable LLDP-MED notifications.
Syntax
[no] lldp mednotification
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This option sends out SNMP trap notifications to designated target stations at
the interval specified by the lldp notification-interval command
(page 4-215). Trap notifications include information about state changes in
the LLDP MIB (IEEE 802.1AB), the LLDP-MED MIB (ANSI/TIA 1057), or
organization-specific LLDP-EXT-DOT1 and LLDP-EXT-DOT3 MIBs.
• SNMP trap destinations are defined using the snmp-server host command
(page 4-64).
• Information about additional changes in LLDP neighbors that occur between
SNMP notifications is not transmitted. Only state changes that exist at the time
of a trap notification are included in the transmission. An SNMP agent should
therefore periodically check the value of lldpStatsRemTableLastChangeTime
4
LLDP Commands
4-219