Show Snmp User; Table 4-25 Show Snmp User - Display Description - Edge-Core ES4524M-PoE Management Manual

4
Command Line Interface
• Before you configure a remote user, use the snmp-server engine-id
command (page 4-67) to specify the engine ID for the remote device where
the user resides. Then use the snmp-server user command to specify the
user and the IP address for the remote device where the user resides. The
remote agent's SNMP engine ID is used to compute authentication/privacy
digests from the user's password. If the remote engine ID is not first
configured, the snmp-server user command specifying a remote user will
fail.
• SNMP passwords are localized using the engine ID of the authoritative agent.
For informs, the authoritative SNMP agent is the remote agent. You therefore
need to configure the remote agent's SNMP engine ID before you can send
proxy requests or informs to it.
Example
Console(config)#snmp-server user steve group r&d v3 auth md5 greenpeace
priv des56 einstien
Console(config)#snmp-server user mark group r&d remote 192.168.1.19 v3
auth md5 greenpeace priv des56 einstien
Console(config)#

show snmp user

This command shows information on SNMP users.
Command Mode
Privileged Exec
Example
Console#show snmp user
EngineId: 01000000000000000000000000
User Name: steve
Authentication Protocol: md5
Privacy Protocol: des56
Storage Type: nonvolatile
Row Status: active
SNMP remote user
EngineId: 80000000030004e2b316c54321
User Name: mark
Authentication Protocol: mdt
Privacy Protocol: des56
Storage Type: nonvolatile
Row Status: active
Console#
Field
EngineId
User Name
4-74

Table 4-25 show snmp user - display description

Description
String identifying the engine ID.
Name of user connecting to the SNMP agent.