Ceiling Fan Assembly - Emerson CF380SW00 Owner's Manual

3. Ceiling Fan Assembly

3.13
Place the ceiling cover over the downrod (Figure 13).
Be sure that the ceiling cover and the motor coupler cover
are both oriented correctly (Figure 13).
3.14
Route the three 80" motor leads through the hanger ball
(Figure 14).
Reinstall the hanger ball on the downrod as follows:
Position the pin through the two holes in the downrod and
align the hanger ball so the pin is captured in the groove in
the top of the hanger ball (Figure 14).
Pull the hanger ball up tight against the pin and securely
tighten the setscrew
(Figure 14).
Loose setscrew could create fan wobble.
3.15
The fan comes with black, blue and white leads that are
80-inches long.
Measure up approximately 6 to 9-inches above top of
hanger ball/4.5" downrod assembly (Figure 15).
Cut off excess leads and strip back insulation 1/2-inch from
end of leads.
in the hanger ball
(Continued)
Figure 13
4.5" DOWNROD
PHILLIPS HEAD
SETSCREW
Figure 14
1/2-INCH
6 TO 9
INCHES
Figure 15
Please contact 1-800-654-3545 for further assistance
9
DOWNROD
CEILING
COVER
PIN
HANGER BALL
BLUE WIRE
BLACK WIRE
WHITE WIRE
HANGER
BALL
emersonfans.com
U.L. Model No.: CF380