Ceiling Fan Assembly - Emerson AVONDALE CF810SW00 Owner's Manual

52” ceiling fan

Hide thumbs Also See for AVONDALE CF810SW00:

Owner's manual (17 pages)

Table Of Contents

Table of Contents

This Manual Is Designed to Make it as Easy as Possible for You to Assemble,

Tools Needed for Assembly

One Phillips head screwdriver

One 1/4" blade screwdriver

One 5/16" open end wrench, or pliers

Three wire connectors (supplied).

Materials

Wiring outlet box and box connectors must be of type

required by the local code. The minimum wire would be

a 3-conductor (2-wire with ground) of following size:

1. Remove the hanger ball by loosening the setscrew in

the hanger ball until the ball falls freely down the

downrod (Figure 1). Remove the pin from the

downrod, then remove the hanger ball. Retain the pin

and hanger ball for reinstallation in Step 5.

2. Separate, untwist and unkink the three 80" motor

leads. Route the motor lead wires through the

downrod. Align the clevis pin holes in the downrod

with the holes in the motor coupler. Install the clevis

pin and secure with the hairpin clip (Figure 2). The

clevis pin must go through the holes in the motor

coupler and the holes in the downrod. Be sure to

push the straight leg of the hairpin clip through the

hole near the end of the clevis pin until the curved

portion of the hairpin clip snaps around the clevis pin.

The hairpin clip must be properly installed to prevent

the clevis pin from working loose. Pull on the

downrod to make sure the clevis pin is properly

installed.

WARNING

It is critical that the clevis pin in the motor coupler is

properly installed and the setscrew securely tightened.

Failure to verify that the pin and setscrew are properly

installed (as shown in Figure 2) could result in the fan

falling.

3. While pulling up on the downrod, securely tighten the

two setscrews in the motor coupler.

4. Make sure the grommet is properly installed in the

coupler cover, then slide the coupler cover on the

downrod until it rests on the motor housing. Place the

ceiling cover over the downrod. Be sure that the

ceiling cover and the coupler cover are both oriented

correctly (Figure 3).

Install, Operate and Maintain Your Ceiling Fan

One stepladder

One wire stripper