ProCurve 2626 Management And Configuration Manual page 325

TFTP: Copying a Configuration File to a Remote Host.
Syntax: copy < startup-config | running-config > tftp < ip-addr > < remote-file >
This command copies the switch's startup configuration (startup-config file)
to a remote TFTP host.
For example, to upload the current startup configuration to a file named
sw4100 in the configs directory on drive "d" in a remote host having an IP
address of 10.28.227.105:
ProCurve# copy startup-config tftp 10.28.227.105
d:\configs\sw4100
Xmodem: Copying a Configuration File from the Switch to a Serially
Connected PC or Unix Workstation. To use this method, the switch must
be connected via the serial port to a PC or Unix workstation to which you
want to copy the configuration file. You will need to:
■ Determine a filename to use.
■ Know the directory path you will use to store the the configuration file.
Syntax: copy < startup-config | running-config > xmodem < pc | unix >
For example, to copy a configuration file to a PC serially connected to the
switch:
1. Determine the file name and directory location on the PC.
2. Execute the following command:
ProCurve# copy startup-config xmodem pc
3. After you see the following prompt, press
Press 'Enter' and start XMODEM on your host...
4. Execute the terminal emulator commands to begin the file transfer.
File Transfers
Transferring Switch Configurations
.
[Enter]
A-19