ProCurve 2626 Management And Configuration Manual page 117

Figure 7-3. Example of Executing the Console Command with Multiple Parameters
Configure
the
individua l
parameters.
Save the
changes.
Boot the
switch.
Figure 7-4. Example of Executing a Series of Console Commands
For example, to use one command to configure the switch with the following:
■ VT100 operation
■ 19,200 baud
No flow control
■
■ 10-minute inactivity time
■ Critical log events
you would use the following command sequence:
The switch implements the Event Log change immediately. The switch implements
the other console changes after executing
You can also execute a series of console commands and then save the
configuration and boot the switch. For example:
Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Telnet
write memory reload
and .
7-7