ProCurve 2626 Management And Configuration Manual page 197

Syntax: [no] qos-passthrough-mode
write memory
reload
The above command sequence enables QoS pass-through
mode. The no form of the command sequence disables QoS
pass-through mode. (Default: Disabled)
For example:
ProCurve Switch 2824(config)# qos-passthrough-mode
Command will take effect after saving configuration and
reboot
ProCurve Switch 2824(config)# write memory
ProCurve Switch 2824(config)# reload
This command can be enabled and disabled only from the switch's CLI. QoS
passthrough mode cannot be enabled or disabled through either the switch's
menu or web browser interfaces.
Once enabled, this feature adds qos-passthrough-mode to the switch's startup­
config file. For example, in an otherwise default configuration, executing show
config lists the startup-config file (with QoS pass-through mode enabled) as
follows:
Figure 10-9. Example of the Startup-Config File Listing with QoS Pass-Through
Mode Enabled
QoS Pass-Through Mode on the Series 2800 and 4100gl Switches
Indicates QoS Pass-
Through mode enabled.
Port Status and Basic Configuration
10-27