Displaying Spanning Tree Configuration Details; Using The Cli To Configure Ports - ProCurve 2626 Management And Configuration Manual

Port Status and Basic Configuration
Viewing Port Status and Configuring Port Parameters
10-10
ProCurve(config)# show interface config
Port Settings
Port Type | Enabled Mode
------- --------- + ------- ------------ --------- ----
1 10/100TX | Yes
2 10/100TX | Yes
3 10/100TX | Yes
4 10/100TX | Yes
5 10/100TX | Yes
6 10/100TX | Yes
7 10/100TX | Yes
Figure 10-6. Example Show Interface Config Command Listing, 2600 Switch

Displaying Spanning Tree Configuration Details

To view detailed statistics on spanning tree operation for different ports on
the Series 2600 and 2800 switches, use the show spanning-tree command.
Syntax: show spanning-tree <port-list> detail
Lists 802.1D and 802.1w port operating statistics for all ports,
or those specified.
You can also use this command to view spanning tree parameters on a static
trunk (see page 12-9). For information on how to configure spanning tree, see
the chapter on "Spanning-Tree Operation" in the Advanced Traffic Manage -
ment Guide.

Using the CLI To Configure Ports

You can configure one or more of the following port parameters. For details
on each option, see Table 10-1 on page 10-4.
Syntax: [no] interface <[ethernet] port-list>
disable | enable
speed-duplex
<10-half |100-half | 10-full | 100-full | 1000-full | auto |
auto-10 | auto-100 | auto-1000 >
flow-control
Note that in the above syntax you can substitute an "int" for "interface" and an
"e" for "ethernet"; that is int e <port-list>.
Current Configured Mode
Flow Ctrl MDI
Auto Disable MDIX
Auto Disable MDIX
Auto Disable MDIX
Auto Disable MDIX
Auto Disable Auto
Auto Disable Auto
Auto Disable Auto