ProCurve 2626 Management And Configuration Manual page 241

C a u t i o n
Switch "A"
with ports set
to LACP
passive (the
default).
Switch "A"
with ports set
to LACP
active.
Figure 12-10. Example of Criteria for Automatically Forming a Dynamic LACP Trunk
Syntax: interface < port-list > lacp active
This example uses ports C4 and C5 to enable a dynamic LACP trunk group.
ProCurve(config)# interface c4-c5 lacp active
Removing Ports from a Dynamic LACP Trunk Group. To remove a port
from dynamic LACP trunk operation, you must turn off LACP on the port. (On
a port in an operating, dynamic LACP trunk, you cannot change between LACP
Active and LACP passive without first removing LACP operation from the
port.)
Unless STP is running on your network, removing a port from a trunk can
result in a loop. To help prevent a broadcast storm when you remove a port
from a trunk where STP is not in use, HP recommends that you first disable
the port or disconnect the link on that port.
Dynamic LACP trunk cannot automatically form because both
ends of the l nks are LACP passive. i
(In this case STP blocking is needed to prevent a loop.
Dynamic LACP trunk automatically forms because both
ends of the links are LACP and at least one end s LACP
active. (STP is not needed, and the clear advantages are
increased bandwidth and fault-tolerance.
Port Trunking
Port Status and Configuration
Switch "B"
with ports set
to LACP
passive (the
default).
Switch "B"
with ports set
to LACP
passive (the
default).
i
)
12-17