ProCurve 2626 Management And Configuration Manual page 230

Port Trunking
Port Status and Configuration
N o t e
12-6
ProCurve(config)# interface c1-c4
ProCurve(eth-c1-c4)#_
ProCurve(eth-c1-c4)# disable
2. Change all four ports to LACP-passive and re-enable the ports.
ProCurve(eth-c1-c4)# lacp passive
ProCurve(eth-c1-c4)# enable
If you change the port trunk configuration on a link, ensure that the port trunk
configuration on the other end of the link matches the new configuration.
On Switch 2800 Series devices, ensure that all ports in a dynamic trunk belong
to the same port group. The Switch 2800 Series devices do not support trunks
comprised of ports from different port groups. (Refer to "Trunk Group Bound­
ary Requirement for Switch 2800 Series Devices" in table 12-3 on page 12-8.)
Static Trunk: The switch uses the links you configure with the Port/Trunk
Settings screen in the menu interface or the trunk command in the CLI to create
a static port trunk. The switch offers LACP and Trunk static trunks.
Table 12-1. Trunk Types Used in Static and Dynamic Trunk Groups
Trunking Method LACP
Dynamic
Static
Trunk
Yes No
Yes Yes