Sntp Unicast Time Polling With Multiple Sntp Servers - ProCurve 2626 Management And Configuration Manual

Figure 9-14. Example of TimeP with Time Sychronization Disabled
Disabling the TimeP Mode. Disabling the TimeP mode means to configure
it as disabled. (Disabling TimeP prevents the switch from using it as the time
synchronization protocol, even if it is the selected
Syntax: no ip timep
Disables TimeP by changing the TimeP mode
configuration to
For example, if the switch is running TimeP in DHCP mode,
the TimeP configuration as shown below, and disables time synchronization
on the switch.
Figure 9-15. Example of Disabling Time Synchronization by Disabling the TimeP
Mode Parameter
SNTP Unicast Time Polling with Multiple
SNTP Servers
When running SNTP unicast time polling as the time synchronization method,
the switch requests a time update from the server you configured with either
the Server Address parameter in the menu interface, or the primary server in
a list of up to three SNTP servers configured using the CLI. If the switch does
not receive a response from the primary server after three consecutive polling
intervals, the switch tries the next server (if any) in the list. If the switch tries

SNTP Unicast Time Polling with Multiple SNTP Servers

Time Sync Method
Disabled .
Even though the T me Sync Mode is set to T mep, i
time synchronization is d
timep has d isabl ed the T meP Mode parameter.
Time Protocols
option.)
changes
no ip timep
i
isabl ed because no ip
i
9-21