ProCurve 2626 Management And Configuration Manual page 223

Power Over Ethernet (PoE) Operation for the Series 2600-PWR Switches
POE usage is below configured threshold of <1 - 99> %
< slot-# > POE usage is below configured threshold of <1-99> %
Indicates that POE usage in the switch or indicated slot (if the
switch includes module slots) has decreased below the threshold
specified by the last execution of the global power threshold <1 - 99>
command. This message occurs if, after the last reboot, the PoE
demand on the switch exceeded the power threshold and then later
dropped below the threshold value.
Port < port-# > applying power to PD.
A PoE device is connected to the port and receiving power.
Port < port-# > PD detected.
The switch has detected a PoE device connected to the port.
W M M/DD/YY HH:MM:SS chassis:
Message header, with severity, date, system time, and system
module type. For more information on Event Log operation, refer
to the "Troubleshooting" appendix in the Management and
Configuration Guide for your switch.
Ext Power Supply connected but not responding.
The switch detects an external power supply, but is not receiving
power from the device.
Ext Power Supply failure: < fault-type > Failures:
Indicates an external power supply failure where < fault-type > is
one of the following:
• Over Current fault: The ProCurve 600 RPS/EPS or ProCurve
610 EPS reported a fault condition. Contact your ProCurve
support representative.
• Fan fault: A fan in an external power supply has failed.
• Temperature fault: The operating temperature in an external
power supply has exceeded the normal operating range.
• 50V fault: The ProCurve 600 RPS/EPS or ProCurve 610 EPS
reported a fault condition. Contact your ProCurve support
representative.
• 12V fault: The ProCurve 600 RPS/EPS or ProCurve 610 EPS
reported a fault condition. Contact your ProCurve support
representative.
PoE Event Log Messages
11-15