FIRST STEPS
Installation wizard
After installation and electrical connection, basic parameters have to be set in order to assure correct operation.
The easiest way to achieve that is use the Installation wizard. When entering the Installation menu, settings
follow one another when the previous one is confirmed. All required parameters shall be entered and confirmed.
Exit from the menu is possible when all required settings are confirmed or with interruption (key several
times) without changes.
To use instrument on the Profibus/M‐Bus network please note that installation wizard doesn't cover Profibus/M‐
Bus settings. Profibus settings must be done as described in the Appendix C. M‐Bus settings must be done as
described in the Appendix D.
PLEASE NOTE
All settings that are performed through the Installation wizard can be subsequently changed
by means of the Settings menu or via MiQen by means of communication.
Main menu Installation
The menus follow one after another:
START MENU
Start screen is displayed on LCD.
LANGUAGE
Set device language.
DATE (MC350, MC350H ONLY)
Set device date.
TIME (MC350, MC350H ONLY)
Set device time.
CONNECTION MODE
Choose connection and define load connection.
PRIMARY VOLTAGE
Set primary voltage if a voltage transformer is used.
SECONDARY VOLTAGE
Set secondary voltage if a voltage transformer is used; set voltage of low voltage network if connection is direct.
PRIMARY CURRENT
Set primary current if a current transformer is used.
SECONDARY CURRENT
Set secondary current.
COMMON ENERGY EXPONENT (MC350, MC350H ONLY)
Define common energy exponent as recommended in table below, where counter divider is at default value 10.
Values of primary voltage and current determine proper Common energy exponent. For detailed information
see chapter Energy on page 31.
Measuring centres – MC320, MC330, MC350 & MC350H ‐ User's Manual
21