CEStronics WT-I Fitting And Operating Instructions page 48

Programming via programming cable
Further information on the installation and use of the
OMEGA software can be found in the OMEGA Software
Operating Instructions which are available free of
charge at
Fig. 27 – programming via programming cable
To program your wall terminals via the programming cable, you
must remove the cover. The following example shows the
procedure for the CES standard housing.
Proceed accordingly for the other housing series to gain access to
the interface for the programming cable.
Proceed as follows:
Page 48 of 80
www.ces.eu.
OMEGA FLEX wall terminals WT-I/WT-II