CEStronics WT-I Fitting And Operating Instructions page 38

Fitting the wall terminal

The mounting holes of the wall terminal must always
be aligned horizontally, also when the wall terminal is
installed on in-wall switch boxes.
Only use the oblong mounting holes for fastening the fitting

frame.
Ensure that all cables required for the connection are guided

through the fitting frame without being damaged or squeezed.
This completes the fastening of the fitting frame.
Now start with the fitting of the wall terminals. The next two
chapters describe the procedure (see pages 38, 41).
6.2.5 Fitting the WT-I wall terminal
The wall terminal is supplied preassembled. Before fitting, the wall
terminal must first be disassembled.
Follow the steps for disassembling the WT-I wall terminal on

pages 35 ff.
For fitting the wall terminal without the fitting frame, you need
already installed and prepared in-wall switch boxes. All required
cable connections must already be available in the switch box.
The supplied fitting frame is not required in this case.
If you are using fitting frames, please follow the fastening

instructions on page 37 ff.
Page 38 of 80 OMEGA FLEX wall terminals WT-I/WT-II