Introduction; Description - CEStronics WT-I Fitting And Operating Instructions

5

Introduction

5.1

Description

The wall terminals are part of the OMEGA system. This system
component performs the function of physical access control. Wall
terminals are used at locations, where a locking cylinder cannot be
used for this purpose.
Examples for the use of wall terminals include automatic sliding
doors, barrier systems, drive-in controls, rolling and sliding gates,
door systems equipped with the CEMO system, etc. The OMEGA
system is also suitable for door systems already including a door
opener (retrofitting). Also installation in electrical equipment with
controlled access (e.g. copying machines) is possible.
All Mifare transponder media and media according to ISO 14443A
and DESFire EV-1 can be programmed at the wall terminal and
used as authorized locking media. LEGIC-prime and LEGIC-advant
transponder media can also be used.
The wall terminals are available in two types for different purposes
of use:
 WT-I is designed for indoor use and contains the reader module
and the control unit in a single housing.
 WT-II is designed for use in high-security applications. The
reader module is fitted in the unprotected outside area, while
the control unit is installed in the secured interior. You can
decide whether the WT-II only reads outside or both inside and
outside.
With the WT-II wall terminal, the control unit can be installed at a
maximum distance of 20 metres away from the reader module.
The connection between the reader module and the control unit is
established with commercial cables.
In all other respects, the functionality of the WT-II is the same as
that of the WT-I wall terminal.
OMEGA FLEX wall terminals WT-I/WT-II
Introduction
Page 13 of 80