Power Supply - CEStronics WT-I Fitting And Operating Instructions

Fitting the wall terminal
1 Controller terminal (inside terminal)
2 Reader terminal (outside terminal)
3 Screw terminals - reader module to control units
4 Screw terminal for power supply
5 Screw terminals - control unit to reader module
6 Screw terminal for potential free contact (not used)
7 Screw terminal for relays
The length of the cable between the control terminal
and the reader terminal must not exceed 20 metres.
Only the supplied cable may be used. Do not extend
the cable!



Controller terminal RxD  TxD Reader terminal
Controller terminal TxD  RxD Reader terminal
The wall terminal may be damaged by incorrect

power supply.

Do not connect the reader terminal with any power

supply other than the controller terminal.
The reader terminal may only be operated at 3 V.
That voltage is supplied by the controller terminal
(VCC).
Page 32 of 80
Only use J-Y(St)-Y 2  2  0.6 mm² cables for the
connection between the controller terminal and
the reader terminal.
Ensure that the wiring for the WT-II wall terminal
is inverted (crossover, like shown):
NOTICE
OMEGA FLEX wall terminals WT-I/WT-II