Programming Via Programming Cable - CEStronics WT-I Fitting And Operating Instructions

8 Programming via
programming cable
You can also program your locking devices via a cable connection
(see also figure on page 48).
For this purpose, you require the optional programming cable.
The following components are required:
 State-of-the-art standard PC (No. 1,2) with Windows XP™ or
Windows 7™ operating system, 1 GHz processor or higher, at
least 1 GB of RAM, at least 1 GB of free hard disk space
 CD-ROM drive for installing the software from data media
 One free USB port for the use of the programming cable
(optional)
 Monitor with a resolution of 1,024 768 pixel or higher, or a
resolution of 1,024  600 pixel (netbook)
 CEStronics Suite software
 A valid licence for CEStronics Suite software
 At least one locking device (4).
 Programming cable (No. 3, optional)
Satisfy yourself that the OMEGA software has been installed

without errors.
If you have to install drivers manually, follow the directions in

the "Help on the software CD" chapter of the Mifare software
Operating Instructions.
The USB programming cable supports hot
plugging, i.e. you can pull the cable without prior
de-registration of the device at the USB port.
OMEGA FLEX wall terminals WT-I/WT-II

Programming via programming cable

Page 47 of 80