CEStronics WT-I Fitting And Operating Instructions page 35

GnD Ground terminal
TxD Transmit Data terminal
RxD Receive Data terminal
VCC Common Connector Voltage terminal
Ensure that the permitted RF ranges and cable lengths are not

exceeded:
Fig. 11 – permitted RF ranges and cable lengths
As soon as an authorized locking medium grants access, the relays
are switched.
6.2.3 Disassembly of the wall terminals
The wall terminal is supplied preassembled. Before fitting, the wall
terminal must first be disassembled.
Disassembly is similar for all versions of the wall terminal. The
following describes the disassembly for the wall terminal in the
CES standard housing.
For the WT-II wall terminal, you must perform the following steps
also for the reader module.
Disassembly may vary depending on the ordered housing version.
The following tool is required:
 Screwdriver with suitable tips / bits for slotted-head screws and
recessed head (Phillips) screws
To disassemble the wall terminal, proceed as follows:
OMEGA FLEX wall terminals WT-I/WT-II
Fitting the wall terminal
Page 35 of 80