Programming With Omega Software - CEStronics WT-I Fitting And Operating Instructions

5.5 Programming with OMEGA
software
You can also manage and program your locking systems online via
a radio frequency link and Access Points, or alternatively via the
optional programming cable.
The following components are required for this system (see also
next page):
 State-of-the-art standard PC (No. 1,2) with Windows XP™ or
Windows 7™ operating system, 1 GHz processor or higher, at
least 1 GB of RAM, at least 1 GB of free hard disk space
 Network interface card with TCP/IP protocol (for the installation
with Access Points)
 CD-ROM drive for installing the software from data media
 One free USB port for the use of the programming cable
(optional)
 Existing Internet connection for using OMEGA-Quicksupport
 Monitor with a resolution of 1,024 768 pixel or higher, or a
resolution of 1,024  600 pixel (netbook)
 CEStronics Suite software
 A valid licence for CEStronics Suite software
 OMEGA RF-NET Access Point (No. 3, maximum of ten devices
per Access Point)
 At least one locking device (No. 4, locking cylinder, IES, wall
terminal).
 Programming cable or RF-Stick (No. 5, optional)
OMEGA FLEX wall terminals WT-I/WT-II
Introduction
Page 21 of 80