Operating The Wall Terminal; Mifare Locking Media - CEStronics WT-I Fitting And Operating Instructions

Operating the wall terminal

7 Operating the wall terminal
To open your door system with the wall, you require a locking
medium that is authorized for the wall terminal. Please refer to
the enclosed Programming Instructions on how to authorize
locking media.
7.1

Mifare locking media

To perform the locking or unlocking operation, hold your

authorized locking medium (1) in front of the reader (2). The
maximum distance is 50 mm.
Fig. 24 – permitted RF ranges
The green LED in the wall terminal goes on to signal enable status
and the connected door system opens.
During the set opening time you can pass through the door.
During this opening time, the wall terminal does not respond to
any other locking media.
If you are using a locking medium that is not
authorized to enable the wall terminal and/or long-

range reader, the red LED of the wall terminal or
the long-range reader flashes four times and you
hear four successive beeps. In this case, no
coupling is established with your connected door
system and you do not have access.
Page 44 of 80 OMEGA FLEX wall terminals WT-I/WT-II