Siemens SIMOCODE pro Manual page 117

PFDavg with low demand rate according to
IEC 61508, 99, 100, 102
PFHD, 106
PFHd with high demand rate according to
EN 62061, 99, 100, 102
PL, 106
PLC, 106
Power consumption, 94
Power loss ride-through time, 94
ProdIS, 106
PROFIsafe address, 48
PROFIsafe monitoring time (F_WD_Time), 102
Pulse duration, 101
PZ, 106
R
Rated control supply voltage Us according to
DIN EN 61131-2, 93
Rated impulse withstand voltage Uimp, 94
Rated insulating voltage Ui, 94
Rated switching capacity of relay enabling circuits, 94
Rated uninterrupted current of relay enabling
circuits, 94
Recovery time after opening of the safety circuits, 101
Recovery time after power failure, 101
Relay enabling circuits, 94
Relay outputs, 94
Replacing a DM-F Local or a DM-F PROFIsafe, 55
RESET in the event of a fault, 44
Response time in error-free state/worst case delay time
(Tmax/TWCDT), 102
Response time when error is present/one fault delay
time (TOFDT), 102
RTU, 106
S
Safe isolation according to IEC 60947-1, 94
Safety chain, 39
Safety Integrity Level, 15
Safety notices for mounting and wiring, 23
Safety-related function, 17, 20
Actuators, 17
Sensors, 17
Safety-related tripping, 15
Safety-specific technical data of the DM-F Local
fail-safe digital module, 99
Safety-specific technical data of the DM-F PROFIsafe
fail-safe digital module, 102
SIMOCODE pro - Fail-Safe Digital Modules
Manual, 11/2017, NEB631679702000/RS-AA/002
Safety-specific values for 1-channel sensor
evaluation, 100
Safety-specific values for 2-channel sensor
evaluation, 99
Scope, 11
Screw mounting, 26
SELV, 106
Sensing, 39
Sensor circuit, 59
Sensor circuit (only in conjunction with DM-F Local), 60
Sensors, 17
Service and support, 10
SET/RESET button, 97, 98
Setting of the F-monitoring time, 52
Setting the configuration, 43
SF, 106
Shock resistance (sine pulse), 93
Short-circuit protection for relay enabling circuits/relay
outputs, 94
SIL, 106
SIL claim limit according to
IEC EN 62061, 99, 100, 102
Simultaneity, 45
Standard function (non-safety-related), 20
Stop category according to DIN EN 60204-1, 100, 102
Storing the set PROFIsafe address, 49
Switching rate of the relay enabling circuits, 94
System interfaces, 93
T
T1 value (mission time) according to
IEC 61508, 100, 102
Target group, 9
Technical Assistance, 14
Technical data of the DM-F Local and DM-
F PROFIsafe fail-safe digital modules, 93
Technical data of the DM-F Local fail-safe digital
module, 96
Technical data of the DM-F PROFIsafe fail-safe digital
module, 98
TIA, 106
Tightening torque, 95
TN, 106
TOFDT, 106
TT, 106
TWCDT, 106
Typical circuit diagram of a reversing starter with
safety-related tripping via an emergency stop control
device, maximum level SIL 3 or PL e, 61
Index
117