Jumper Description; Sata Dom Power / Pci Vio (Jp1) - Diamond Systems Venus VNS766-4GD Manual

8 JUMPER DESCRIPTION

Following drawing shows only the connectors and jumper blocks on the board. The default jumper positions are
shown in blue.
Jumper
JP1
JP2

8.1 SATA DOM Power / PCI VIO (JP1)

The 7th pin of the SATA connector J20 can be configured for SATA DOM or for SATA cable. By default, 7th pin of
J20 is connected to ground for the SATA cable.
The IO voltage of PCI data/address lines can be configured for 3.3V or 5V.
The default jumper location is shown in Figure 4
Venus User Manual Rev 1.1d
Figure 3 Default Jumper locations
Description
SATA DOM Power, PCI VIO
LVDS LCD VCC and Backlight
www.diamondsystems.com Page 28