Table of Contents
Advertisement
1.3.
Programming modes
The control has the following programming functions:
Program
constants
Tools
Change view
Program library
You select one of the programming modes in the manual- or automatic operation mode while
the controller is in the 'stop'-status.
In this mode you program the general parameters
for bend programming.
In this mode you program and edit the tools.
There are 30 different punches and 30 different
dies to program in the program memory.
Key to switch between various pages of a bend.
It also serves to return to an active program.
Open the library with bend programs on the
control.
V0812, 1.3
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DA-52s and is the answer not in the manual?
Questions and answers