Program Settings - Delem DA-52s Reference Manual

4.4.

Program settings

Machine number . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .MN
When there are several bending machines in a factory, it can be useful to give the
control on each machine a unique machine number.
The selected machine number will be stored with the bending program. This number will
be checked when a program is read from USB key. When the machine number does not
match you must confirm to read it anyway or not. If you do not confirm the question the
action will be aborted.
The machine number is also stored in the filenames of tools. When the machine number
is changed in this screen, you are prompted to make a new backup of your tools
because the filenames of all tools have been changed according to the new machine
number.
Angle correction database . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .CD
Toggle function, to switch the database with angle corrections on or off.
Angle corrections are entered in production mode (automatic/step by step). These
corrections are stored in the product program. Beside this, it is also possible to store
these corrections in a general database with angle corrections. This way corrections
that have once been entered for certain bends remain available for future use in other
products.
When this setting is switched on, the control checks during production whether
corrections for similar bends are present in the database. If corrections for certain bends
are available, then they will be offered. On other occasions, corrections can be
interpolated and offered.
The correction database is adjusted by entering new corrections during production.
When the database is enabled with this parameter, all new-entered corrections are
stored in the database.
When searching for similar bends, the control searches for bends that have the same
V0812, 4.4
4.c