Delem DA-52s Reference Manual page 33

properties as the active bend. The following properties of a bend are compared:
- Material properties
- Thickness
- Die opening
- Die radius
- Punch radius
- Angle
The first five properties of a bend must be exactly the same as the active bend to start a
comparison.
If an angle is found with the same value as the angle of the active bend, the correction is
offered.
If no matching angle is found, the control will attempt to interpolate a correction from
already existing corrections. To compute a correction, the following two conditions must
be obeyed:
- If the angle of the active bend must have a maximum difference of 10° with two
adjacent bends.
- The corrections of these two adjacent bends may differ no more than 5°.
Y opening default . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..13
Default Y-axis opening value.
The value programmed here is used as initial value for the parameter 'Y-axis opening'
when making a new bend program.
Default X-axis code . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..XC
Default value for the parameter 'code' in a bend program. This parameter determines
the moment of step change in a bend program. Initially the code parameter is set to the
value programmed here during postprocessing and during programming.
The default value of this parameter = 2.
See chapter 'program edit' for more information about the code parameter.
Default X time. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..XT
Default waiting time for step change. With this parameter you can preset a longer
waiting time when needed for product handling.
Deafult hold time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..HT
Default value for the dwell time, the time the pressbeam stays at the bending position.
V0812, 4.5