Parameters Explanation - Delem DA-52s Reference Manual

2.2.2. Parameters explanation

Drawing number . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..DN
A name or description of the program. The maximum length is 20 characters.
Number of bends . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..NB
The number of bends in the current program.
When this value is increased, the additional bends are copied from the last bend.
When this value is decreased, the superfluous bends are deleted.
Angle selection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..ma
Selection of the programming mode for the Y-axis.
0 = absolute: program the absolute Y-axis position for a bend.
1 = a: program the angle to bend. The required Y-axis position is computed.
Depending on this parameter, either the parameter 'angle' or the parameter 'bend
position' will appear in a bend step.
Thickness . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..TH
Thickness of the sheet.
Material . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..M
Selection of one of the programmed materials, which are used to calculate the bending
depths. The control contains 4 preprogrammed materials and 2 programmable ones. In
total, 6 materials can be programmed on the control. See the chapter about
programming constants how to program materials.
Use the arrow keys up/down to move the cursor to the
desired parameter.
Use the arrow keys left/right to browse between the various
pages of the bend program.
After pressing the enter key the programmed value will be
placed at the corresponding parameter.
V0812, 2.3