Figure 4-10 Side Rail And Slide Assembly - HP A3765A Installation Manual

Figure 4-10 Side Rail and Slide Assembly

7. From the front, pull the side rail away from the cabinet frame disengaging the front tab
(1) and rail bolt (3), then lift the back of the side rail away from the cabinet frame,
disengaging the hook tab (2) from the rectangular slot in the cabinet frame.
8. Repeat steps 5 through 7 for each side rail (left or right, upper or lower).
Side Rail and Slide Assembly Replacement:
1. Refer to Figure 4-10. At the back of the cabinet, position the side rail in line with the
two press nuts, and insert the hooked tab (2) into the second rectangular slot in the
cabinet frame. Then insert the front side rail bolt (3) through the matching hole in the
front cabinet frame.
2. Replace the nut (4) and the three (one front, 2 back) mounting screws and tighten.
3. Repeat steps 1 and 2 for each side rail and slide assembly.
4. Replace the shelf assembly (refer to Shelf Assembly Replacement).
5. Replace the computer lock out assembly (refer to Computer Lock Out Assembly
Replacement).
Chapter 4
Removal and Replacement Procedures
Removal and Replacement Procedures
4-19