Table of Contents
Advertisement
Removal and Replacement Procedures
Removal and Replacement Procedures
Figure 4-8 Computer Lockout Assembly Diagram
2. Remove the two mounting screws
safety channel bracket
3. Lift the safety rod out of the cabinet.
4. The lower lock out assembly can now be removed (if necessary), by repeating steps 1
and 2 on the lower assembly.
NOTE
If the lower lock out assembly was not removed, steps 1 and 2 of the
replacement procedures can be skipped. Start with step 3.
Computer Lock Out Assembly Replacement:
1. Align the lower safety channel bracket with the two cabinet mounting holes and insert
mounting screws and tighten.
2. Align the center slide, with the tabs toward the front of the cabinet, over the center hole
in the shelf assembly and insert the slide screw and washers.
3. Place the safety rod
4. Align the upper safety channel bracket
insert mounting screws
5. Align the center slide, with the tabs toward the front of the cabinet, over the center hole
in the shelf assembly and insert the slide screw and washers
The computer lock out assembly is a manual device and should be centered during normal
cabinet operation.
4-16
from the top safety channel bracket, and pull the
(2)
off the safety rod
(3)
into the bottom lock out assembly.
(4)
(3)
and tighten.
(2)
.
(4)
with the two cabinet mounting holes and
(1)
.
Chapter 4
Advertisement
Table of Contents
