Shelf Assembly; Figure 4-9 Shelf Assembly Diagram - HP A3765A Installation Manual

Shelf Assembly

The shelf assembly has the middle rails and slides attached to the shelf plate. To remove
and replace either the upper or lower the shelf assembly, perform the following steps.
Shelf Assembly Removal:
1. Remove the D Class computer (refer to D Class Computer Removal instructions).
2. Remove the computer tray (refer to Computer Tray Removal).
3. Remove the computer lock out assembly (refer to Computer Lock Out Assembly
removal).
4. Be sure the side rail and slides are fully pushed back into the cabinet for front shelf
assembly mounting screw access.
5. Refer to Figure 4-9. Remove the four (one at each corner) shelf assembly mounting
screws . These screws hold the shelf assembly
(1)

Figure 4-9 Shelf Assembly Diagram

6. From the front of the cabinet, slide the shelf assembly
shelf fits in a slot (3) between the lower lip and upper part of the rail and slide assembly.
Chapter 4
Removal and Replacement Procedures
Removal and Replacement Procedures
to the side rail assemblies
(2)
out of the cabinet. Note the
(2)
.
(3)
4-17